3/27/2018
Posted by 
How To Install Handlebar Risers On Goldwing Rating: 7,6/10 943reviews

Place a blanket folded several times over the fuel tank to help prevent any damage during the installation of the risers. Loosen the two 14mm riser mounting nuts located on the bottom side of the upper steering head. Loosen the four handlebar top clamp 6mm socket head screws. It will help having a second person to hold the handlebars while you change the risers. Remove the four screws from the clamps and then remove the clamps. Pull the handlebars up off the risers, pull them back and rest them on top of the blanket.

How To Install Handlebar Risers On Goldwing

This is a handlebar riser kit. These risers are made by MBL Innovations and is designed to move the handlebars to a more comfortable position. Patch Gore The Darkness 2. Gold Wings have long been considered the pinnacle of comfort as far as motorcycles go, but many riders find that the handlebar positioning requires too much of a reach to allow them to ride for long.

Remove the nuts from the bottom of the risers and remove the risers carefully without allowing the risers to rotate, as this will scratch the clear coating on the upper steering head. Using the bolts, lock washers and washers supplied install the new risers making the bolts finger tight only.

First off I did not know there were handlebar risers made for Goldwings till I saw a set sold on here. I have researched the Kuryakyn risers and reviews are very good. 3-Position Handlebar Risers for GL1800 by Kuryakyn. Adjust your handlebars to make your Gold Wing the most. Installation was fairly easy if you are comfortable.

(NOTE; again, take care not to allow the risers to rotate as this will scratch the clear coating on the upper steering head). Magix Video Easy 5 Hd V5.0.1.100 Keygen [kp]. Place the handlebars back up onto the new risers.

Install the new top clamps supplied using the four M8 X 30mm socket head screws supplied. Set the height of the handlebars to the desired position, tighten the front bolts first and then the rear securely. Lbs.) (There should be no gap between the riser and clamp at the front side) Tighten the two riser mounting bolts securely. Turn the handlebars all the way to the left and then right checking for any pulling or binding of the wires, hoses or cables. Buku Disiplin there.

Check to see that the throttle returns freely on its own when the handlebars are at full left and full right turn THIS STEP IS VERY IMPORTANT FOR OBVIOUS SAFETY REASONS! If you have a windshield installed it may be necessary to reroute the throttle cables, wires or hoses around the other side of the windshields mounting hardware to obtain adequate free play and free throttle return. You may also wish to remove the plastic clips or cable tie which secure the wiring to the handlebars and secure them to the brake hose and clutch cable (not the throttle cables) for a cleaner appearance. Place a blanket folded several times over the fuel tank to prevent any damage during the installation of the risers. Loosen the two 19mm riser mounting nuts located on the bottom side of the upper steering head. Pry out the chrome plugs from the heads of the four handlebar top clamp bolts using a knife blade.

Loosen the four handlebar top clamp 6mm socket head screws. It will help having a second person to hold the handlebars while you change the risers. Remove the four screws from the clamps and then the clamps. Pull the handlebars up off the risers, pull them back and rest them on top of the blanket. Remove the nuts from the bottom of the risers and remove the risers. Insert the two supplied spacer tubes into the riser mounting holes on the upper steering head. Using the bolts, lock washers and washers supplied install the new risers making the bolts finger tight only.