The DVR has a Factory Reset switch to the left of the Alarm Output connectors on the rear panel. This switch will only be used on the rare occasions that you want to return all the settings to the original factory settings. Driver Acer Q65h2. When using the Factory Reset, you will lose any settings you have saved. To reset the unit, you will need a straightened paperclip: 1. Turn the DVR off.

Turn it on again. While the DVR is initializing, the front panel LEDs will blink. When the front panel LEDs blink, poke the straightened paperclip to the unlabeled hole in the left of the Alarm Output connectors. Hold the switch until all the LEDs on the front panel are lit. NOTE: When the DVR successfully resets to factory defaults all the LEDs on the front panel flash five times. Release the reset switch.

Download >>Download Scopetronic engineers manual Read Online >>Read Online Scopetronic engineers manual homeguard scopetronic. Hi There Im Still in trouble with the Scopetronic Homeguard Alarm. Help Scopetronic Homeguard Alarm. Fsx Fs2crew Airbus Extended X Hotfix Torrent. Could you give me a copy of the engineer manual?

All of the DVR's settings are now at the original settings it had when it left the factory. Jan 02, 2018 . Be sure you understand the difference between a master code and the technician code. A master code lets you program other codes (and do some other harmless stuff). The technician code lets you do anything in the panel.

If no master code is known you will need to default the panel. Do that by turning off power and disconnecting the battery.

Reconnect the battery or plug pack and within 10 seconds enter 971300 on the code pad. That will wipe the eeprom back to factory defaults, and reinstate user 1 as a master code with a value of 1234. Don't even think of doing any of this without an INSTALLER manual. (Not the same thing as the USER manual).

Better still, get an alarm tech familiar with DAS or CADDX products to program it for you. Worth every penny. After that you can add/delete users with your own master code using the much simpler User manual.

Any code can be set to be a master code (that is you can have more than one master code) Jun 25, 2014 . Disable the hood microswitch. Just unplug it. That and the cabin sensor are the most probably reasons the alarm will go off. Alarms are useless.

Totally effin useless. So it goes off.then whaddya going to do. Java Plug In Version 1.4 2. Shoot someone? Call the police? Or listen to it drain the battery over and over again. But.you can't disable the alarm totally. The bmw engineers have tied it into the main computer.

You can however disable the sensors one by one so it doesn't set off the alarm. Hood sensor.Hood sensor.that's the culprit. Jun 04, 2009 . I haven' t researched your car for you just yet!

I thought Id quickly mention the common method for reprogramming your alarm & remote, If you still require assistance then just ask me and I will find more about your car:) Common Methods for resetting/re-learning code • Factory Fitted Alarms/ Central Locking / remote comes on ignition key. Insert ignition key, turn key to accessories / red, press & hold lock/unlock for a few secs.remove key,exit vehicle and try un/lock doors &/or alarm (Some models differ slightly & require engine on or manual use of door locks whilst resetting. • Aftermarket /Non-Factory / remote is separately operated Most use a small back-up battery usually located within the loudspeaker/Alarm unit itself under the bonnet, Remove this battery for a short period to reset the remote code The access panel for the backup battery is never in an obvious place. Look carefully:) Jul 14, 2008 .